2.Set up

Please refer to the following manual for details of installation.
Installation Guide
The TILT adjusting lever allows you to change the TILT angle of all multi part cameras simultaneously.
When operating the TILT adjustment lever, slide it to the right and left with the lever pinched and raised slightly. The multi part cameras move in the TILT direction. For the TILT adjustment lever, refer to the following.
TILT adjusting lever
The TILT adjustment lever can change the angle of the multi part cameras to the following three levels. The angle of tilt of the camera relative to ceiling and horizontal conditions is shown.
Refer to the installation video for the TILT adjustment lever operation.
Set up
[N](Near):47°
[M](Middle):40°
[F](Far):33°

・The factory shipping position is [M].


・Depending on the improvement of the product, the appearance may differ from the actual product to the extent that it does not affect the product operation.


(1)
Slide the TILT adjustment lever to the right and left by lifting the lever with your finger.
Slide to the right to adjust to the angle of [N]. Use to shoot near areas.
Slide to the left to adjust to the angle of [F]. Use to shoot far areas.
After adjusting the angle with the TILT adjusting lever, change the [Tilt adjustment lever position] on the camera-side screen to apply the adjusted angle to the PTZ. Positioning accuracy may be affected by clicking or centering movement.
This section describes the range of shooting with each TILT angle.
An image is shown. The actual shooting range may differ depending on the installation environment.
[F]
[M]
[N]
Shooting range
Infinite (whole area)
Radius 53.4 m(175.2 ft)
Radius 20.6 m (67.6 ft)
Dead angle
Radius of 2.4 m(7.9 ft)
Radius of 1.6 m(5.2 ft)
Radius of 0.8 m(2.6 ft)
[F]
[M]
[N]
Shooting range
Infinite (whole area)
Radius 15.3 m(50.2 ft)
Radius 5.9 m(19.4 ft)
Dead angle
Radius of 1.2 m(3.9 ft)
Radius of 0.8 m(2.6 ft)
Radius of 0.4 m(1.3 ft)