1.2 Camera Settings

1. After completing Step 4 in Section 1.1, the Audio detection settings are automatically applied to the camera.

 

2. Camera Settings

1. Go to [Setup] > [Alarm] > [Notification] > [TCP alarm protocol notification].

Note:
The camera [Alarm] > [Notification] settings are automatically configured when the camera is registered with Security Center.
If alarm notifications are not received, ensure that the [Destination port] and [Destination server address] are configured correctly.

 

3. Genetec Settings

3.1 Event Notification Settings

Configure the settings to allow Security Desk to receive audio alarm events.

1. Open Security Desk and go to [Options] > [Events] > [Event options].
2. Check [Audio alarm], then click [Save].

 

3. Go to [Security Desk] > [Tasks] > [Monitoring].
4. Click [Monitoring] in the bottom-left menu, then click [+] to add the target camera.

3.2 Event-to-action Settings (Optional)

When an Audio detection event occurs, you can configure actions to be triggered automatically.
As an example, this section describes how to display alarm notifications on the [Alarm monitoring] tab.

3.2.1 Alarm Settings

1. Open [Config Tool].
2. Go to [Config Tool] > [Alarms].
3. Click [Alarm].

 

4. Enter "Audio detection" in [Name], and then click [Apply].

 

5. Go to the [Properties] tab.
6. Click [+] in Recipients, and select the target users. Click [Add].
7. Click [Apply].

 

3.2.2 Action Settings

1. In Security Center, go to [Config Tool] > [Automation] > [Actions].
2. Click [+]. 

 

3. Set the parameters as follows.

 

• When: Select [Audio alarm].
• From: Select the target camera.
• Action: Select [Trigger an alarm].
• Alarm: Select the alarm you created.

4. Click [Save].

 

4. How It Works

4.1 Verifying Event Reception on the Monitoring Tab

1. Open Security Desk and go to the [Monitoring] tab.
2. When an Audio detection event occurs, an [Audio alarm] appears in the [Monitoring] tab.

 

4.2 Verifying Alarm Reception on the Alarm monitoring Tab

1. Open Security Desk and go to the [Alarm monitoring] tab.
2. When an Audio detection event occurs, an [Audio detection] alarm appears in the [Alarm monitoring] tab.

 

 

Genetec Security Center 5.13 / Driver Pack 13.5