2.Set up

Please refer to the following manual for details of installation.
Installation Guide
This section describes the settings that support the adjustment of the angle of view when installing the camera.
Live image pages configuration panels>[Detailed setting]>[Camera detailed setting]>[Display]>Advanced Menu>[Easy Setup]>>Click [Easy installation] to display the easy installation page.
1.
Select the installation method from the four displayed patterns.
The display layout, camera display position, and image rotation are automatically set as shown in the table below according to the selected installation method.

Display layout
Camera display position
Image Rotation
Install on a celling
Left/right placement
Left: Camera 1
Right: Camera 2
Camera 1: 0° (Off)
Camera 2: 0° (Off)
Install on a wall (horizontal direction)
Left/right placement
Left: Camera 1
Right: Camera 2
Camera 1: 180° (Upside-down)
Camera 2: 180° (Upside-down)
Install on a wall (vertical direction)
Install with the right pipe (camera 1 is on the upper side).※1
Up/Down placement
Up: Camera 1
Down: Camera 2
Camera 1: 0° (Off)
Camera 2: 180° (Upside-down)
Install on a wall (vertical direction)
Install with the left pipe (Camera 2 is on the upper side)※2
Up/Down placement
Up: Camera 2
Down: Camera 1
Camera 1: 180° (Upside-down)
Camera 2: 0° (Off)
 

*1 When installing on a wall (horizontal direction), move the camera as shown in the illustration below before adjusting the direction of the camera.


 

*2 When installing on a wall (vertical direction), move the camera as shown in the illustration below before adjusting the direction of the camera.


1.
While checking the screen, manually adjust the direction of each camera.

2.
Adjust the angle of view using the zoom button.<WV-S85402-V2L><WV-U85402-V2L>
When the display layout is set to the left/right
When the display layout is set up/down