Audio Detection

2. select target camera.

3. Selecting Hardware will open the [Hardware] screen.

4. Set [Audio alarm] and [Alarm level] , finally click [Apply].

  

<Camera settings>

1. When 4 is executed on the Genetec side, the settings are reflected in "Audio alarm" and "Alarm level" of "Audio detection" on the camera side.

 

2.  Set [TCP alarm notification] of [Notification] to ”ON”.

3. Check [Alarm] in [Destination of notification] and set [Destination server address] to the address of the PC where Genetec is installed.

Note: When [Transmission setting for each motion detection area] is set to "On", alarm notifications other than motion detection are not performed.

 

<Genetec settings>

1. In case start record with the [audio detection] notification, select [Setting tool] - [System] .

2. Select [General Settings] - [Action].

3. Click [+] at the bottom of the screen.(*Add an item)

 

4. Click [＋] to open [Event -to-action].
    Set as appropriate, and finally click [Save].

Ex.
・When: If "Audio detection" occurs, select "Audio alarm".
・From: Select target camera.
・Action: To start recording, select "Start recording".
・Camera: Select camera to record.
・Recording duration: Set as appropriate.

5.  After saving, the registered contents are displayed.

 

<Confirmation method>

1.  Select [Security Desk] - [Tasks] - [Camera events]  .

 

2. Check ”Target camera”.

3. Check ”Audio alarm”.

4. Finally click [Generate report].

 

You can select the period.
You can further refine your selection.

 

5. When "Audio detection” occurs and the alarm is notified normally, "Audio alarm" or "Audio analytics event" is displayed in the event list.
* In case not checked the bookmark in 3, the identification target is not displayed in the details of the voice analysis event.
* The [Audio alarm] notification is received even if [Motion detection] in [Video analytics] in [Config Tool] is set to "OFF".（*The settings of 1 to 5 in ”Genetec side settings" are necessary.）  

      

6. Select what you want to check from the displayed list and double-click to play the recorded video.