4.Clean up

・Turn off the power before starting operation. Doing so may result in injury.

・Do not apply or use organic solvents such as benzene and thinner. The enclosure may become discolored. Follow the precautionary statement when using chemical foil.

・Do not loosen or remove the screws not specified in the operation manual.

・Clean with lens cleaning paper (for cleaning cameras and eyeglasses).

・Alcohols should be used when solvents are used. Do not use glass cleaners or thinners.

・To clean the Dome cover, wash out hard sand grains and other adhered materials by pouring fresh water containing no lubricant or silicone substance using a hose or spray. If the stain is not removed, wipe with a soft sponge soaked with the above fresh water.

・Do not wipe dry (e.g., spread oil on surfaces or damage the advanced ClearSight Coating).

・Use neutral detergent for dishware and rinse thoroughly after use if dirt does not come off after wiping. If detergents other than neutral (weakly alkaline or slightly acidic) are used, the hydrophilic capacity of the product may deteriorate or the surface coating may peel off.

・Do not use organic solvents such as benzene and thinner.

・If spraying is used, use it after emptying to remove the initial impurities.

・Clean the Dome cover with a cleaning paper, etc., since stain on the inside of the cover and the Dome cover may affect the infrared reflections.

・If the Advanced ClearSight Coating of the Dome cover becomes ineffective due to improper maintenance, the Dome cover needs to be replaced (paid) to restore the Advanced ClearSight Coating to its original state. Contact your dealer or contractor.