|
|
|
・ i-PRO Management Software (optional) ・ Network Recorder (optional) ・ i-PRO Active Guard |
|
|
|
・ This product defines/learns the normal condition and notifies the specified notification destination of the alarm when it is determined to be abnormal. It is useful in several cases, including the following: - To prevent a door for storing important items from being closed or opened. - To quickly grasp the shortage condition on shelves and replenish them. - To search for exhibits and other items when they are taken away from the place where they should be. - To warn about leaving immediately if a car is parked in a parking prohibited area. ・ This product has the following features. - Learn up to three normal conditions and create a Detector. - Set and learn up to 16 detection areas. - Adjust alarm notification conditions according to the operating environment. See below for details. →4.3 Advanced settings - Backup/upload data stored on an SD Memory Card. |
|
|
|
|
|
[Ex. (2MP(1080p) Camera)] To detect missing shelves as shown in the figure below, set as follows. ※In this case, set the detection target at the lowest stage of the image to be reflected smaller. [Target Height] = 0.82 + 0.98 = 1.80ft. [Target Size] = 0.66ft. [Target Pixels] = 100pix the lower detection limit |
|
|
|
・ The difference in brightness between the background and the subject is small. ・ Image brightness is low, such as at night. ・ The subject is out of focus. ・ The subject is blurred. ・ The subject is too small or too large. ・ The subject is white or blackened. ・ Light conditions, such as outdoors and windows, are easily changed. ・ External light such as sunlight and car headlights, and reflection of light such as water pools and glass come in. ・ Strong external light is inserted to create a subject and other shadows. ・ The camera lens is wet or dirty. ・ The camera is shaking. |
|
・ If you change the camera image settings before or after learning, it may cause a failure or false alarm. When you change the [Image capture mode] or [Image rotation] settings of the camera, perform the following again. ・ When using in an environment where color images and black-and-white images are switched, it is recommended that you train color images and black-and-white images individually. ・ Images of illumination assumed during operation must be collected and learned. ・ When using under IR-LED, you need to train with images under IR-LED. ・ Enable the [Exclude a person from scene change] setting when you use the camera in environments where people can be seen. However, if a person is not detected correctly, they may not be excluded correctly. If a non-human entity is detected as a human being, it may be excluded. ・ Enable [Abandonment detection] when using the product for detecting obsolete objects (suspicious objects, etc.). ・ If a false alarm is generated at low illumination, activating the setting to stop the alarm at low illumination prevents false alarms. ・ This product cannot be set or trained from multiple PCs at the same time. ・ If you execute [Reset to the default] of the camera, the setting data of this product and the data in the SD memory card (Learning images, Detector) will not be initialized. However, since it may be affected by the image quality settings of the camera itself, please check the operation again. ・ The message ID of TCP alarm notification is "59" for AI scene change detection alarm and "60" for the alarm when the SD memory card cannot be accessed. |