4Operation

When the required settings are completed, open the camera's web browser to display the image and start operation.
a: Locus, b: detection frame, c: alarm notification
Alarm notification
When i-VMD detects a moving object, an alarm notification will be displayed.
1: CROSS LINE (CROSS LINE), 2: INTRUDER (INTRUDER), 3: LOITERING (LOITERING), 4: DIRECTION (DIRECTION)
When alarm notification is clicked while alarm is generated, all alarms are reset.
Alarm is also notified when an alarm input is received with a terminal alarm or when a command alarm is received.
Detection frame (red frame, blue frame)
When a motion is detected, this motion is displayed in a blue frame. When the detected movement enters the Detection area and an alarm is generated, this movement is displayed in a red frame.
"i-VMD Information addition” can be set to ON/OFF.
Locus
The Locus where the alarm frame (red frame) moves is displayed in green.
Displays the Locus for the most recent 3 seconds.
Displayed when the alarm frame (red frame) is set to be displayed in the "i-VMD Information addition" and "Additional information type" settings.

・If you configure the i-VMD Detection area and then change the [Image/Audio]-[Image capture mode] or [Basic]-[Image rotation] in the Camera Settings menu, the Detection area, mask area and depth may be misaligned or initialized. If the [Image capture mode] or [Image rotation] is changed, check the Detection area and mask area settings and the depth settings again.


・If you change the zoom settings after you configure the Detection area for i-VMD, the Detection area and mask area may be misaligned. If you change the zoom settings, check the Detection area, mask area, and depth settings again.