11.7 Configure the preset positions (Preset position setup menu)
Click the [Setup>>] button of “Preset position” on the [Image/Position] tab of the “Image/Audio” page (→11.5 Configure the settings relating to image adjust, zoom/focus, preset position, privacy zone and VIQS [Image/Position]).
It is possible to register, edit and delete the preset positions on this page.
When the position and zoom factor are adjusted, the adjustment will be applied immediately to the currently displayed image on the [Image/Position] tab.
IMPORTANT
•
This function is available when “Cropping [16:9](30fps mode)” is selected for “Image capture mode” and “On” is selected for “H.264 transmission” of “H.264(1)”. (→11.4 Configure the settings relating to the camera operations [Cam. Function]).
Note
•
“Preset position” can be set up to a maximum of 16 positions.
Register the preset positions
1.
Select a preset position number. Numbers 1 to 16 can be selected.
→
The selected preset position number will be displayed in the “Position No” area.
When the selected number has already been registered, the camera will move to the selected preset position.
2.
Move the image position to the desired direction.
3.
The setting for “Dwell time” can be configured for each position independently.
4.
Click the [Set] button.
Preset position setting: Position No
[Dwell time]
Select a dwell time (duration the image stops for at each preset position) for the preset sequence operation.
5s/ 10s/ 20s/ 30s
•
Default: 10s
[Set] button
Registers the preset positions.
[Delete] button
Deletes the preset position specified by the position number.
Note
•
If position numbers 1 to 4 are deleted, the default positions are set.
[Close] button
Click this button to close the “Preset position” setup menu.