Configure the settings relating to the image capture mode [JPEG/H.264]

11.1 Configure the settings relating to the image capture mode [JPEG/H.264]

Click the [JPEG/H.264] tab on the “Image/Audio” page. (→9.1 How to display the setup menu, 9.2 How to operate the setup menu)

[Image capture mode]

Select an image capture mode from the following.

8 mega pixel [16:9](30fps mode)/8 mega pixel [16:9](15fps mode)/12 mega pixel [4:3](15fps mode)/5 mega pixel [4:3](30fps mode)/4 mega pixel [16:9](30fps mode)/Cropping [16:9](30fps mode)

•

Default: 8 mega pixel [16:9](15fps mode)

IMPORTANT

•

The positions of areas may move out of alignment when the “Image capture mode”, “Upside-down”, or “Zoom” setting is changed when the following area settings are configured. Therefore we recommend that you configure each area setting after configuring the “Image capture mode”, “Upside-down”, or “Zoom”.

–

Mask area (→11.5.2 Set mask areas)

–

Privacy zone (→11.8 Configure the settings relating to the privacy zone (“Privacy zone” setup menu))

–

VMD area (→13.5 Configure the VMD settings [VMD area])

–

VIQS area (→11.9 Configure the VIQS setting)

–

Preset position (→11.7 Configure the preset positions (Preset position setup menu))

Note

•

When “On” is selected for “VIQS” and the setting value for the aspect ratio is changed from “4:3” to “16:9”, make sure that the VIQS setting value does not exceed the maximum designated range.